How to repair a dent in a car door

Fixing a Car Door Dent - Autos. How do you remove a dent from a car door? How much does auto dent repair for doors cost? How to remove car dents yourself?

To use you just stick the suction cup puller in the center of the dent.

If you can identify the exact spot that the panel was hit, that would be the best spot to attach the suction cup. You’ll want to clean the spot that you’re applying the puller to thoroughly before trying to stick it to the car. These kits typically use a bridge-type tool (as shown above) with legs that will straddle the dent. The first step is to find a reliable toilet plunger that has reliable grip and suction when its being applied to the car door.

Don’t always settle for the old worn out plunger as this could make your dent worse an it could even cause some marks if the rubber is old. The plunger will then create a suction on the dent. When you can notice that there is enough suction, you can firmly pull the plunger.

If you are lucky enough, this method can prevent you from visiting an auto collision repair shop in Reseda.

As for self-repair, rather than a cloth wrapped steel headed hammer, I. This is a loaded question, and hard to answer truly. If you can post a picture on a photo web site (like photobucket) and publish the link here I can give you the best answer possible. Generally speaking, there are dents, such as those left by footballs or soccer balls hitting a body panel,. Just splash some hot water on both the plunger and the dent and start pushing and. If you are an advanced car tinkerer then you may just feel more comfortable about taking the entire door off to use a rubber mallet and repair the dent from the inside of the panel.

Its important to note that to never use a metal hammer if you a new to this as you could create smaller unsightly dents marks thanks to a metal hammer. Start by removing the paint inside and around the dent with 24-grit paper. Switch to 80-grit sandpaper and hand-sand the entire dent. Use the same sandpaper to rough up and feather the paint around the edges of the dent.

Clean the entire area with wax remover and a clean rag. With your sandpaper wrapped around a sanding block (rubber sanding blocks are best and can be purchased in automotive or home repair stores), start sanding the filler using 150-grit sandpaper. Sand lightly and evenly over the entire surface of the repair with broad circular strokes. Sand past the edge of the filler to create a smooth transition. A plunger works well for large, shallow dents in a door or the hood.

Start by rubbing the edge of the plunger with a damp rag to moisten the suction surface.

Then, position the plunger over the dent and press the plunger towards your car. Wet the surface around the dent with water and dish soap to make the surface slippery and wet. Place the plunger in the center of the dent.

Pull the plunger back gently to pull the dent out. Just rub the wax over the scratched paint until it fills it up. A great tip if you don’t want to drive a scratch up car to an important meeting. If you can, use a small rubber mallet and go behind the dent and very lightly tap it out.

Warning: Do not use a mallet or a hammer on plastic, as it is likely to crack. WIDE APPLICATION – The mini hot melt glue gun with glue sticks is not only for car dent removal,but also can be used in DIY home repair. INSPIRED DESIGN – Bridge dent puller with pcs glue tabs is.

Just moisten the edge of the rubber, place the plunger over the dent , establish suction by pressing down on the handle, and then pull it toward you. It may take a couple of tries before the metal pops back to normal. This technique works especially well on large expanses of metal, such as doors and fenders, if they have only been bent inward.

Apply heat to the dented panel. Turn on the hair dryer and use it to blow hot air over the dent and the surrounding area for one to two consecutive minutes.