Repairing nail holes in drywall

How to patch large nail holes in drywall? What do I use to fill nail holes in drywall? Nail and screw holes in drywall are small but they can be rough on the surface, therefore they require special attention. One method of repairing this type of roughness is to take a box knife and cut away the surface layer, then filling the cavity with Spackle or drywall mud , this method works fine except that it requires several layers of Spackle, causes more work and takes longer to complete a repair than it probably should.

Learn a simple technique to repair nail holes in drywall with our helpful video, made in partnership with Sherwin-Williams.

Fill the damaged area and the holes left by the new screws with lightweight patching compound. Use a flexible putty knife to apply the compound and smooth it. Apply two or three coats, allowing each to dry completely before recoating. Popped drywall nails and screws are common in old and new homes alike.

The new screws should barely dimple into the drywall. Drive a new nail immediately adjacent to the popped nail using the hammer and nail set. Try to nail the new nail as close to the original hole as you can.

The head of the new nail will overlap the old nail , preventing the old nail from slipping out again.

Use your drywall screws for this. Place the screw in the center of the wood framing and keep it at least inch away from the edge of the nail pop area. Put a screw on either side of the nail pop area. Use the cap of the 4- in -Patch Plus Primer to (very) lightly sand down the wall to remove any paint or drywall flakes.

Grab a small glob of spackle that is just larger than the hole you want to fill. Place the putty knife right above the hole and drag it downward to apply the spackle, focusing on the hole with about 0. Use spackling paste to fill tiny nail holes , small holes , and dents. Drive a nail or screw pop into the drywall , then cover them with joint compound to conceal them. In the center of the nail pop, place the tip of nail punch, and tap in with hammer.

As you tap in the nail pop the sheet rock mud or old Spackle will fall out and break off. If you discover a screw. Measure the hole then cut a scrap piece of drywall that is slightly larger than the hole’s diameter. Place drywall piece over the damaged area (image 1) and trace around it with a pencil (image 2). Use a drywall or reciprocating saw to cut out the area within the traced lines (image 3).

Cut two pieces of 2xslightly larger than the hole. Albert recommends spackling or caulk or Elmer’s Wood Glue, and you can use your finger to work it in and then level it.

You need a material that adheres and doesn’t crack. Also useful to have on hand: DAP Patch Stick Spackling Nail Hole and Crack Filler. When patching screw holes in textured drywall , you will need to follow up by re-texturing the patch.

On very small holes , you can use a similar product often called spackle. Like joint compoun spackle is made from a. Holes larger than about inch in diameter require some.